ARM ARM7TDMI Fiche technique Page 40

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 42
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 39
Programmer’s Model
ARM7TDMI Data Sheet
ARM DDI 0029E
3-14
Open Access
3.9.10 Exception priorities
When multiple exceptions arise at the same time, a fixed priority system determines
the order in which they are handled:
Highest priority:
1 Reset
2 Data abort
3 FIQ
4 IRQ
5 Prefetch abort
Lowest priority:
6 Undefined Instruction, Software interrupt.
Not all exceptions can occur at once:
Undefined Instruction and Software Interrupt are mutually exclusive, since they each
correspond to particular (non-overlapping) decodings of the current instruction.
If a data abort occurs at the same time as a FIQ, and FIQs are enabled (ie the CPSR’s
F flag is clear), ARM7TDMI enters the data abort handler and then immediately
proceeds to the FIQ vector. A normal return from FIQ will cause the data abort handler
to resume execution. Placing data abort at a higher priority than FIQ is necessary to
ensure that the transfer error does not escape detection. The time for this exception
entry should be added to worst-case FIQ latency calculations.
3.10 Interrupt Latencies
The worst case latency for FIQ, assuming that it is enabled, consists of the longest
time the request can take to pass through the synchroniser (
Tsyncmax
if
asynchronous), plus the time for the longest instruction to complete (
Tldm
, the longest
instruction is an LDM which loads all the registers including the PC), plus the time for
the data abort entry (
Texc
), plus the time for FIQ entry (
Tfiq
). At the end of this time
ARM7TDMI will be executing the instruction at 0x1C.
Tsyncmax
is 3 processor cycles,
Tldm
is 20 cycles,
Texc
is 3 cycles, and
Tfiq
is 2
cycles. The total time is therefore 28 processor cycles. This is just over 1.4
microseconds in a system which uses a continuous 20 MHz processor clock. The
maximum IRQ latency calculation is similar, but must allow for the fact that FIQ has
higher priority and could delay entry into the IRQ handling routine for an arbitrary
length of time. The minimum latency for FIQ or IRQ consists of the shortest time the
request can take through the synchroniser (
Tsyncmin
) plus
Tfiq
. This is 4 processor
cycles.
Vue de la page 39
1 2 ... 35 36 37 38 39 40 41 42

Commentaires sur ces manuels

Pas de commentaire

Tiffen Lowel PRO Power LED Accessory Battery podręczniki

Instrukcje obsługi i podręczniki użytkownika dla Oświetlenie Tiffen Lowel PRO Power LED Accessory Battery.
Dostarczamy 1 pdf podręczników Tiffen Lowel PRO Power LED Accessory Battery do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika






Więcej produktów i instrukcji dla Oświetlenie Tiffen

Modele Rodzaj dokumentu
Lowel PRO Power LED Instrukcja Użytkownika   Tiffen Lowel PRO Power LED User Manual, 2 strony
Lowel GL-1 Power LED Instrukcja Użytkownika   Tiffen Lowel GL-1 Power LED User Manual, 4 strony
Lowel Prime LED 200 Instrukcja Użytkownika   Tiffen Lowel Prime LED 200 User Manual, 2 strony
Lowel Blender Original Models Instrukcja Użytkownika   Tiffen Lowel Blender Original Models User Manual, 4 strony
Lowel Tota-light Instrukcja Użytkownika   Tiffen Lowel Tota-light User Manual, 4 strony
Lowel Omni-light Instrukcja Użytkownika   Tiffen Lowel Omni-light User Manual, 4 strony
Lowel Pro-light Instrukcja Użytkownika   Tiffen Lowel Pro-light User Manual, 4 strony
Lowel L-light Instrukcja Użytkownika   Tiffen Lowel L-light User Manual, 2 strony
Lowel V-light Instrukcja Użytkownika   Tiffen Lowel V-light User Manual, 5 strony
Lowel Rifa eXchange Instrukcja Użytkownika   Tiffen Lowel Rifa eXchange User Manual, 4 strony
Lowel i Light Instrukcja Użytkownika   Tiffen Lowel i Light User Manual, 4 strony
Lowel Rifa-lite Instrukcja Użytkownika   Tiffen Lowel Rifa-lite User Manual, 4 strony
Lowel eXchange System Lamphead Instrukcja Użytkownika   Tiffen Lowel eXchange System Lamphead User Manual, 2 strony
Lowel Rifa eX Retrofit Instrukcja Użytkownika   Tiffen Lowel Rifa eX Retrofit User Manual, 2 strony
Lowel Fluo-Tec Instrukcja Użytkownika   Tiffen Lowel Fluo-Tec User Manual, 4 strony
Lowel e-studio Instrukcja Użytkownika   Tiffen Lowel e-studio User Manual, 2 strony
Lowel Caselite ce Instrukcja Użytkownika   Tiffen Lowel Caselite ce User Manual, 4 strony
Lowel Scandles Instrukcja Użytkownika   Tiffen Lowel Scandles User Manual, 8 strony
Lowel SoftCore Instrukcja Użytkownika   Tiffen Lowel SoftCore User Manual, 4 strony
Lowel Ego-sweep Instrukcja Użytkownika   Tiffen Lowel Ego-sweep User Manual, 1 strony